Serum complement C3 lysate assay (C3SP)

Complement C3 lysate is formed during the activation of complement, and complement C3 is cleaved by C3 activating enzyme or the like to form an active fragment. The detection of complement lysate not only reflects the degree of activation of the complement system, but also monitors the condition, aids diagnosis and treatment. Basic Information Specialist classification: cardiovascular examination classification: blood examination Applicable gender: whether men and women apply fasting: fasting Tips: Do not eat too greasy, high-protein foods the day before the blood draw, avoid heavy drinking. The alcohol content in the blood directly affects the test results. After 8 pm on the day before the medical examination, fasting should be done to avoid affecting the detection of indicators such as blood glucose in the second sky. Normal value Serum complement C3 lysate was negative or <0.094 g/L. Clinical significance Increased values ​​of complement C3 are found in autoimmune diseases such as systemic lupus erythematosus, rheumatoid arthritis, kidney disease, parasitic diseases, bacterial infections, and the like. High results may be diseases: lupus erythematosus, pancreatic cancer, leukemia precautions (1) Be careful to avoid air bubbles when pouring agar plates. (2) The pipette used to dilute serum and antiserum must be fixed. Dilute the reference serum and patient serum using a uniformly calibrated pipette, otherwise use the same pipette. Other equipment is also best unified. (3) The agar concentration used must be strictly controlled, and prevented from drying after dispensing. Do not dissolve repeatedly. Do not boil for too long when dissolved, and evaporate with water. The temperature of 56 °C should be strict, too hot will destroy the serum, too cold and easy to coagulate. Mix quickly and fully. (4) The position after the serum is added must be kept horizontal to prevent deformation of the diffusion ring. (5) The serum of the subject must be fresh. If the conditions are not allowed, the serum can be stored frozen or diluted and stored. It will have little effect within a few days. After a long time, the C3 value will increase. Inspection process First, the tested serum was diluted 5 times with 0.1 g/L thiomersal physiological saline, and then added to the corresponding wells of the agar plate in sequence (each plate should be used for more than 5 different concentrations of C3 reference serum as a control). The agar plate was dehumidified. Inside, the measurement results were measured after 37 ° C for 48 h. The obtained C3 reference serum precipitation ring diameter is compared with the corresponding value on the originally drawn standard curve. The sedimentation ring of the lowest concentration C3 reference serum should not be 0.1 mm larger than the original, the highest concentration is not more than 0.3 mm, and the other three concentrations are not more than 0.2 mm. Otherwise, it should be re-measured. Not suitable for the crowd There are no special taboos. Adverse reactions and risks No relevant information.

The material in this site is intended to be of general informational use and is not intended to constitute medical advice, probable diagnosis, or recommended treatments.