Glucose Oxidase Electrode Membrane Method

The glucose oxidase electrode membrane method (GOD membrane method) is an electron reutilization current counting device that uses an enzyme to react with glucose to read the amount of electrons and convert it into a glucose concentration reading. It has the advantage that the price is relatively cheap and the result is relatively accurate. This test should be performed on an empty stomach. Do not expose the probe to the air. After using for a period of time, you must go to the repair station for a calibration. Basic Information Specialist classification: cardiovascular examination classification: blood examination Applicable gender: whether men and women apply fasting: fasting Analysis results: Below normal: Low blood sugar may be hypoglycemia. Normal value: Normal value: 60-240mg/dl Above normal: Hyperglycemia may be diabetes. negative: Positive: Tips: Do not expose the probe to air before checking. Normal value The blood sugar level is raised from 60 mg/d to 240 mg/dL. (mg/dl) Clinical significance Abnormal result The blood glucose level is displayed on the display of the blood glucose meter. The abnormal blood glucose monitoring results were >240 mg/dl (13.3 mmol/L) or abnormally low <60 mg/dl (3.3 mmol/L), and there was a problem with blood sugar. Need to check the crowd Middle-aged and elderly people, people with abnormal blood sugar. Low results may be diseases: high hypoglycemia results may be diseases: diabetes considerations Forbidden before examination: blood test on an empty stomach. Do not expose the probe to the air. Requirements for inspection: After using for a period of time, you must go to the repair station for a calibration. Inspection process Select the blood of the skin on both sides of the fingertips of the left-hand ring finger to collect blood, because the blood vessels on both sides of the finger are rich, and the nerve endings are less distributed. Blood collection in this area is not only painless but also full of bleeding, and will not affect the result due to insufficient bleeding. Before the blood collection, the arm can be drooped for 10 to 15 seconds, so that the fingertips are congested. After the needle is inserted, gently push the blood vessels on both sides of the finger to one third of the front end of the finger to allow the blood to slowly overflow, and measure after blood collection. Not suitable for the crowd People with leukemia, people with diseases that are not easy to heal. Adverse reactions and risks Bleeding: After blood collection, use sterile cotton lump or other disinfecting hemostatic articles to tighten the needle to stop bleeding, especially for patients with coagulopathy should be given sufficient time to avoid bleeding.

The material in this site is intended to be of general informational use and is not intended to constitute medical advice, probable diagnosis, or recommended treatments.